Walt, The only sensors close to the water pump on this engine that could leak coolant would be the coolant temp sensor. There is a camshaft position sensor located next to the thermostat housing but that wouldn’t make sense as far as leaking coolant. Verify the leak location before going further. You may wish to donate to Troublecodes.net to provide more information in the future. Thank you for your consideration and good luck with your coolant leak.
Alex
3 years ago
can anyone direct me to where the knock sensors are for the 2005 300 hemi ( awd ) not sure if different from rwd. i looked under the car next to where the starter on one side but don’t see them, other side i don’t see them either. Most likely over looking.
Alex, The knock sensors are bolted to the outside of the cylinder block right below the exhaust manifold. Should see it. A small bolt in the center of a 1″ black round roughly quarter-inch thick coin. Let us know if you have any other issues.
Nathaniel Olson
4 years ago
Hello William. It does use both. It has an oil temp sensor and an oil pressure sensor.
William Keith Fitchett Sr.
4 years ago
Does the 2007 Chrysler 300 c 5.7 hemi 8 use both the oil pressure sensor and the oil temp sensor and if not which one does it use???
Colleen S Thompson
4 years ago
This is beautiful! Thank you for this great diagram.
2009 jeep 5.8l, coolant leaking from a sensor near water pump, 4 wire connector, held in by bolt. What sensor is this?
Walt,
The only sensors close to the water pump on this engine that could leak coolant would be the coolant temp sensor.
There is a camshaft position sensor located next to the thermostat housing but that wouldn’t make sense as far as leaking coolant. Verify the leak location before going further.
You may wish to donate to Troublecodes.net to provide more information in the future.
Thank you for your consideration and good luck with your coolant leak.
can anyone direct me to where the knock sensors are for the 2005 300 hemi ( awd ) not sure if different from rwd. i looked under the car next to where the starter on one side but don’t see them, other side i don’t see them either. Most likely over looking.
Alex,
The knock sensors are bolted to the outside of the cylinder block right below the exhaust manifold. Should see it. A small bolt in the center of a 1″ black round roughly quarter-inch thick coin.
Let us know if you have any other issues.
Hello William. It does use both. It has an oil temp sensor and an oil pressure sensor.
Does the 2007 Chrysler 300 c 5.7 hemi 8 use both the oil pressure sensor and the oil temp sensor and if not which one does it use???
This is beautiful! Thank you for this great diagram.