Mazda OBD/OBD2 Codes >> Mazda 89-93 MPV & 88-90 323/626/MX-6 & 88-92 929

1989-1993 Mazda MPV 2.6/3.0L           Engine Code: G6/JE

1988 – 1990 323 1.6L                          Engine Code: B6

1988 – 1990 626/MX-6 2.2L               Engine Code: F2

1988 – 1992 929 3.0L                          Engine Code: JE

Mazda

Accessing Trouble Codes

Checking
  • Ensure engine is at normal operating temperature.
  • Switch ignition OFF.
  • Jump test connector (green 1 pin) to ground Image 1 [1]
  • Switch ignition ON.
  • Count MIL flashes and compare with trouble code table
  1. 1.2 second flashes indicate the ‘tens’ of the trouble code Image 2 [A]
  2. 0.4 second flashes indicate the ‘units’ of the trouble code Image 2 [D]
  3. A 1.6 second pause (MIL OFF) separates ‘TENS’ and ‘UNITS’ Image 2[C]
  4. A 0.4 second pause (MIL OFF) separates each flash Image 2 [B]
  5. A 4 second pause separates each trouble code Image 2 [E]
  6. For example: Trouble code 22 displayed Image 2

Clearing Trouble Codes

  • Ensure ignition switched OFF
  • Disconnect battery ground lead
  • Depress the brake pedal for a minimum of 5 seconds
  • Reconnect battery ground lead
  • Jump test connector (Green 1 pin) to ground Image 1 [1]
  • Switch ignition ON
  • Wait 6 seconds
  • Start engine
  • Allow engine to reach normal operating tempertature
  • Run engine at 2000 rpm for 2 minutes
  • Allow to idle
  • Check MIL for further trouble codes
  • Switch ignition OFF
  • Remove jump lead
  • Repeat checking procedure to ensure no data remains in ECM fault memory

Trouble Codes

  • See Mazda

Mazda