GM OBD/OBD2 Codes >> GM 92 5.7L VIN 7 TBI

GM

92 5.7L VIN 7 TBI
13Oxygen sensor voltage stays between 0.35 and 0.55 volts for 60 seconds.
14Coolant temperature sensor signal indicates a temperature of over 275° F for 2 seconds.
15Coolant temperature sensor signal indicates a temperature colder than -27° F for 30 seconds after the engine has been running for at least 30 seconds.
21TPS voltage was above 2.5 volts for 8 seconds when the MAP sensor signal showed manifold vacuum to be 15 pounds or more.
22TPS voltage was under 0.2 volts when the engine was running.
23Inlet air temperature sensor signal showed an air temperature below 22° F after the engine has been running for 5 minutes.
24When engine speed was between 1200 and 4400 RPM and throttle position angle was less than 3%, the MAP signal showed low voltage (high manifold vacuum) for at least 5 seconds.
25Inlet air temperature sensor signal showed an air temperature over 302° F after the engine has been running for 5 minutes. On Brougham models the inlet air temperature sensor signal shows a temperature above 297° F with an engine speed greater than 35 MPH.
32EGR open command did not change the MAP sensor signal. Normal EGR flow should cause slight decrease in manifold vacuum which would change MAP sensor signal.
33MAP sensor signal voltage was too high (low vacuum) for 5 seconds when throttle opening was under 4%.
34MAP sensor signal voltage was too low (high vacuum) when engine speed was over 1200 RPM.
42The EST signal did not change when the ECM applied bypass voltage to the ignition module.
43The ECM did not detect a knock signal during near wide open throttle operation with coolant temperature above 194° F or the knock signal was present for 4 seconds or more during normal engine operation.
44Oxygen sensor voltage was under 0.25 volts for 50 seconds of closed loop operation. On Brougham models the oxygen sensor voltage was under 0.2 volts.
45Oxygen sensor voltage was over 0.75 volts for 30 seconds with a throttle angle above 20%. On Brougham models the oxygen sensor voltage was over 0.7 volts.
51PROM error.
54Fuel pump voltage was not present at fuel pump sense line for 2 seconds after the ECM has sent the fuel pump on command.
55ECM error. Replace ECM.
Subscribe
Notify of
guest

This site uses Akismet to reduce spam. Learn how your comment data is processed.

0 Comments
Inline Feedbacks
View all comments