GM OBD/OBD2 Codes >> GM 92 2.3L VIN D MFI

GM

92 2.3L VIN D MFI
13Oxygen sensor voltage stays between 0.35 and 0.55 volts for 30 seconds after engine had been running for at least 40 seconds.
14Coolant temperature sensor signal indicates a temperature of over 285° F after engine had been running for at least 2 minutes, or if coolant temperature sensor was shorted to ground.
15Coolant temperature sensor signal indicates a temperature colder than -38° F for 60 seconds.
16ECM did not receive 2X pulses while receiving 1X pulses.
197X reference signal problem. ECM has detected either too many or too few pulses between sync signal within 4 minutes.
21TPS voltage was above 4.0 volts for 5 seconds when the MAP sensor signal showed manifold vacuum to be 15 pounds or more, or the TPS voltage was greater than 4.7 volts with throttle closed.
22TPS voltage was under 0.2 volts for 5 seconds when the engine was running.
23Inlet air temperature sensor signal showed an air temperature of -29° F after the engine has been running for 5 minutes and 20 seconds.
24Vehicle was not in park or neutral for 20 seconds when throttle position signal was over 7% with engine speed between 1600 and 3600 RPM and the MAP signal showed low manifold vacuum.
25Inlet air temperature sensor signal showed an air temperature over 318° F with a vehicle speed greater than 15 MPH.
26Quad-driver sense voltage shows a low voltage for 5 seconds when battery voltage should be present or if the sense voltage shows battery voltage for 20 seconds when a low voltage should be present.
33MAP sensor signal voltage was too high (low vacuum) for 5 seconds when throttle opening was under 12%.
34MAP sensor signal voltage was too low (high vacuum) for 0.2 seconds when engine speed was under 1200 RPM or when throttle opening was over 15.2%.
35Idle speed was over 175 RPM outside the desired engine speed commanded by the ECM for at least 5 seconds.
41ECM had received 8-2X reference pulses without receiving any 1X reference pulses.
42The EST circuit had an open or a ground and the signal did not change when the ECM applied bypass voltage to the ignition module.
43The ECM did not detect a knock signal during near wide open throttle, or the knock signal was present for 3.67 seconds or more during normal engine operation.
44Oxygen sensor voltage was under 0.3 volts for 50 seconds of closed loop operation.
45Oxygen sensor voltage was over 0.75 volts for 50 seconds of closed loop operation.
51EPROM error.
53ECM sees a battery voltage of more than 17.1 volts for 0.2 seconds with ignition on.
62Vehicle speed was less than 5 MPH when vehicle was in 2nd or 3rd gear, or vehicle speed was greater than 50 MPH when vehicle was in 1st or 2nd gear.
65Fuel injector driver current did not reach 4 amps, injectors commanded "ON" longer than the calibrated pulse width and battery voltage was more than 9 volts for 10 seconds.

 

Subscribe
Notify of
guest

This site uses Akismet to reduce spam. Learn how your comment data is processed.

0 Comments
Inline Feedbacks
View all comments