| 90-91 5.7L VIN 8 | |
|---|---|
| 13 | Oxygen sensor voltage stays between 0.35 and 0.55 volts for 60 seconds. Engine was at normal operating temperature and had been running for at least 2 seconds after start with a throttle angle above 5%. |
| 14 | Coolant temperature sensor signal indicates a temperature of over 266° F for 3 seconds. |
| 15 | Coolant temperature sensor signal indicates a temperature colder than -38° F for 3 seconds. |
| 21 | TPS voltage was above 2.5 volts for 3 seconds when the MAP sensor signal showed manifold vacuum to be 15 pounds or more, or TPS was above 4.5 volts at any time. |
| 22 | TPS voltage was under 0.2 volts for 3 seconds when the engine was running. |
| 23 | Manifold air temperature sensor signal showed an air temperature below -22° F for 12 seconds after the engine has been running for 5 minutes. |
| 24 | Vehicle speed was 0 MPH when engine speed was between 900 and 3000 RPM and throttle position angle was less than 2% for at least 4 seconds. |
| 25 | Manifold air temperature sensor signal showed an air temperature over 302° F for 12 seconds after the engine has been running for 4 minutes and vehicle speed was above 5 MPH. |
| 32 | EGR open command did not change MAP sensor signal. Normal EGR flow should cause slight decrease in manifold vacuum which would change MAP sensor signal. |
| 33 | MAP sensor signal voltage was too high (low vacuum) for 1 second when throttle opening was under 2%. |
| 34 | MAP sensor signal voltage was too low (high vacuum) when engine speed was under 600 RPM or the engine speed was over 600 RPM with a throttle position angle above 6%. |
| 41 | Faulty or incorrect MEM-CAL. |
| 42 | The EST signal did not change when the ECM applied bypass voltage to the ignition module. |
| 43 | The ECM did not detect a knock signal during near wide open throttle operation, or the knock sensor voltage was above 3.62 volts or below 1.44 volts for 0.5 seconds. |
| 44 | Oxygen sensor voltage was under 0.2 volts for 50 seconds of closed loop operation. |
| 45 | Oxygen sensor voltage was over 0.7 volts for 30 seconds of closed loop operation with a throttle angle above 2%. The engine was running for at least 1 minute. |
| 46 | ECM did not receive the proper signal from vehicle anti-theft system when ignition was turned on. |
| 51 | MEM-CAL error. |
| 52 | Engine oil temperature was below -31° F after the engine had been running for 30 minutes. |
| 53 | ECM sees a battery voltage either above 17.1 volts or below 8.0 volts. |
| 54 | Fuel pump voltage was less than 2 volts for 1.5 seconds since the last reference pulse was received. |
| 62 | Engine oil temperature was above 284° F after engine had been running for 30 minutes. |